CHIRPING CHICKEN
SCORE: 37 POINTSMonday, June 5, 2023
Violations Cited
09C
Food contact surface improperly constructed
Design, construction, materials used or maintenance of food contact surface improper. Surface not easily cleanable, sanitized and maintained.
Improper surfaces harbor bacteria in cracks and cannot be properly sanitized
Use stainless steel, approved plastics; no wood except cutting boards; smooth, intact surfaces
02B
Hot TCS Food Not Held at 140°F or Above
Hot TCS food item not held at or above 140 °F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
04A
Food Protection Certificate Not Held by Supervisor
Food Protection Certificate (FPC) not held by manager or supervisor of food operations.
KNOWLEDGE GAP: Establishments without certified managers have 2.5x more critical violations. Lack of food safety knowledge directly correlates with foodborne illness outbreaks. Certified managers reduce outbreak risk by 60% through proper training and oversight.
Obtain Food Protection Certificate immediately through NYC-approved course. Certificate holder must be present ALL operating hours. Post certificate conspicuously. Maintain valid certification (renew every 5 years). Train all staff on food safety basics.
08A
Facility Not Free from Harborage Conditions
Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
04N
Filth Flies Present in Food Areas
Filth flies or food/refuse/sewage associated with (FRSA) flies or other nuisance pests in establishment’s food and/or non-food areas. FRSA flies include house flies, blow flies, bottle flies, flesh flies, drain flies, Phorid flies and fruit flies.
RAPID CONTAMINATION: Flies carry 100+ pathogens on feet and bodies. One fly transfers 2 million bacteria per landing. Feed by vomiting on food. Can contaminate entire prep area in minutes. Major vector for E. coli, Salmonella, Shigella transmission.
Eliminate breeding sites: Clean drains daily, Remove standing water, Empty garbage frequently, Install air curtains/screens, Use fly lights away from food, Clean up spills immediately, Locate and eliminate larval breeding sites (drains, garbage, produce).
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
Violations were cited in the following area(s).