FRESH & CO
SCORE: 22 POINTSMonday, June 6, 2022
Violations Cited
08A
Facility Not Free from Harborage Conditions
Facility not vermin proof. Harborage or conditions conducive to attracting vermin to the premises and/or allowing vermin to exist.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
02G
Cold TCS Food Held Above 41°F
Cold food item held above 41º F (smoked fish and reduced oxygen packaged foods above 38 ºF) except during necessary preparation.
DANGER ZONE GROWTH: Between 41-70°F, E. coli doubles every 30 minutes. Salmonella doubles every 20 minutes at 70-90°F. After just 4 hours above 41°F, bacteria levels can cause severe illness including bloody diarrhea, kidney failure (E. coli), and typhoid fever (Salmonella).
Keep all cold TCS foods at 41°F or below (smoked fish 38°F, shell eggs 45°F). Monitor with calibrated thermometer every 2-4 hours. Ice baths must surround container to food level. Repair refrigeration immediately. DISCARD foods above 41°F for over 4 hours.
04N
Filth Flies Present in Food Areas
Filth flies or food/refuse/sewage-associated (FRSA) flies present in facility’s food and/or non-food areas. Filth flies include house flies, little house flies, blow flies, bottle flies and flesh flies. Food/refuse/sewage-associated flies include fruit flies, drain flies and Phorid flies.
RAPID CONTAMINATION: Flies carry 100+ pathogens on feet and bodies. One fly transfers 2 million bacteria per landing. Feed by vomiting on food. Can contaminate entire prep area in minutes. Major vector for E. coli, Salmonella, Shigella transmission.
Eliminate breeding sites: Clean drains daily, Remove standing water, Empty garbage frequently, Install air curtains/screens, Use fly lights away from food, Clean up spills immediately, Locate and eliminate larval breeding sites (drains, garbage, produce).
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
Violations were cited in the following area(s).