NEW PINANG
SCORE: 43 POINTSMonday, October 7, 2024
Violations Cited
10B
Plumbing Not Properly Installed or Maintained
Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.
WATER CONTAMINATION: Backflow can siphon sewage into water supply, contaminating entire facility. Cross-connections spread pathogens throughout plumbing. Sewage backups create immediate health hazard. Can affect hundreds through contaminated water.
Install backflow preventers on ALL required fixtures. Maintain air gaps (2x pipe diameter minimum). Fix all leaks immediately. Ensure proper drainage - no standing water. Regular plumbing inspection. No direct connections between sewage and water supply.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
20-06
NYC Health Code Violation 20-06
Current letter grade or Grade Pending card not posted
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 20-06 to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Follow NYC Health Code Article 81 requirements. Implement corrective action immediately. Document all corrections. Train staff on proper procedures. Schedule follow-up inspection if critical.
06C
Food not protected from contamination
Food, supplies, or equipment not protected from potential source of contamination during storage, preparation, transportation, display, service or from customer’s refillable, reusable container. Condiments not in single-service containers or dispensed directly by the vendor.
Unprotected food exposed to bacteria, viruses, chemicals, and physical contaminants
Cover all food; store 6 inches off floor; protect from customer contamination; use sneeze guards
04M
Live Roaches Present in Facility
Live roaches in facility's food or non-food area.
DISEASE VECTORS: Roaches carry 33 types of bacteria, 6 parasitic worms, 7 human pathogens. Travel from sewers/garbage to food surfaces. Spread Salmonella, E. coli, Staphylococcus. Trigger severe asthma and allergies. One roach = likely infestation of hundreds.
Immediate elimination required: Professional extermination ASAP, Find and eliminate water sources (roaches need water daily), Seal all cracks/crevices, Deep clean with degreaser, Remove cardboard/clutter, Apply gel baits in non-food areas, Follow-up treatment in 2 weeks.
08C
Pesticide not properly used or stored
Pesticide not properly labeled or used by unlicensed individual. Pesticide, other toxic chemical improperly used/stored. Unprotected, unlocked bait station used.
Improper pesticide use causes chemical contamination and acute poisoning
Licensed applicator only; follow label directions; store away from food; use approved chemicals
06F
Wiping Cloths Not Stored in Sanitizer
Wiping cloths not stored clean and dry, or in a sanitizing solution, between uses.
CONTAMINATION SPREAD: Dirty wiping cloths spread millions of bacteria across every surface wiped. Bacteria double every 20 minutes on damp cloths. One contaminated cloth can spread pathogens to 30+ surfaces, causing facility-wide contamination.
Store wiping cloths in sanitizer AT ALL TIMES between uses: 50-100ppm chlorine or 200-400ppm quaternary ammonium. Change solution when visibly dirty or every 4 hours. Use separate cloths for food contact vs non-food contact. Test sanitizer concentration every 2 hours.
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
02H
Food Not Cooled by Approved Method
After cooking or removal from hot holding, TCS food not cooled by an approved method whereby the internal temperature is reduced from 140 °F to 70 °F or less within 2 hours, and from 70 °F to 41 °F or less within 4 additional hours.
TOXIN PRODUCTION: Slow cooling is the #1 cause of foodborne outbreaks. Clostridium perfringens spores survive cooking and germinate during slow cooling, producing heat-stable toxin. Causes 'buffet illness' affecting hundreds at events. Staph aureus produces toxin that CANNOT be destroyed by reheating.
Cool using approved methods: Shallow pans (2 inches max depth), Ice baths with frequent stirring, Ice paddles, Blast chillers, Cut large items into portions. NEVER cool at room temperature. NEVER stack hot containers. Document cooling times and temperatures.
08A
Facility Not Free from Harborage Conditions
Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
Violations were cited in the following area(s).