RODNEY'S
GRADE NWednesday, March 12, 2025
Violations Cited
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
08A
Facility Not Free from Harborage Conditions
Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
06F
Wiping Cloths Not Stored in Sanitizer
Wiping cloths not stored clean and dry, or in a sanitizing solution, between uses.
CONTAMINATION SPREAD: Dirty wiping cloths spread millions of bacteria across every surface wiped. Bacteria double every 20 minutes on damp cloths. One contaminated cloth can spread pathogens to 30+ surfaces, causing facility-wide contamination.
Store wiping cloths in sanitizer AT ALL TIMES between uses: 50-100ppm chlorine or 200-400ppm quaternary ammonium. Change solution when visibly dirty or every 4 hours. Use separate cloths for food contact vs non-food contact. Test sanitizer concentration every 2 hours.
10D
NYC Health Code Violation 10D
Mechanical or natural ventilation not provided, inadequate, improperly installed, in disrepair or fails to prevent and control excessive build-up of grease, heat, steam condensation, vapors, odors, smoke or fumes.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 10D to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Follow NYC Health Code Article 81 requirements. Implement corrective action immediately. Document all corrections. Train staff on proper procedures. Schedule follow-up inspection if critical.
Violations were cited in the following area(s).