THE MAD DONKEY
SCORE: 29 POINTSWednesday, April 27, 2022
Violations Cited
04C
Bare Hand Contact with Ready-to-Eat Food
Food worker does not use proper utensil to eliminate bare hand contact with food that will not receive adequate additional heat treatment.
DIRECT CONTAMINATION: Hands carry 150+ bacterial species and 3,000-5,000 bacteria per square centimeter. Even 'clean' hands transfer millions of bacteria. Ready-to-eat foods receive no kill step. Bare hand contact is #1 factor in Norovirus outbreaks affecting 20 million Americans annually.
NO bare hand contact EVER with ready-to-eat foods. Use: Single-use gloves (change every hour and between tasks), Tongs/spatulas/spoons, Deli tissue/wax paper. Wash hands before donning gloves. Post signs. This is NON-NEGOTIABLE in NYC.
04A
Food Protection Certificate Not Held by Supervisor
Food Protection Certificate not held by supervisor of food operations.
KNOWLEDGE GAP: Establishments without certified managers have 2.5x more critical violations. Lack of food safety knowledge directly correlates with foodborne illness outbreaks. Certified managers reduce outbreak risk by 60% through proper training and oversight.
Obtain Food Protection Certificate immediately through NYC-approved course. Certificate holder must be present ALL operating hours. Post certificate conspicuously. Maintain valid certification (renew every 5 years). Train all staff on food safety basics.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
10B
Plumbing Not Properly Installed or Maintained
Plumbing not properly installed or maintained; anti-siphonage or backflow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly.
WATER CONTAMINATION: Backflow can siphon sewage into water supply, contaminating entire facility. Cross-connections spread pathogens throughout plumbing. Sewage backups create immediate health hazard. Can affect hundreds through contaminated water.
Install backflow preventers on ALL required fixtures. Maintain air gaps (2x pipe diameter minimum). Fix all leaks immediately. Ensure proper drainage - no standing water. Regular plumbing inspection. No direct connections between sewage and water supply.
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
Violations were cited in the following area(s).