U & I RESTAURANT
GRADE ATuesday, May 31, 2022
Violations Cited
02B
Hot TCS Food Not Held at 140°F or Above
Hot food item not held at or above 140º F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
10B
Plumbing Not Properly Installed or Maintained
Plumbing not properly installed or maintained; anti-siphonage or backflow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly.
WATER CONTAMINATION: Backflow can siphon sewage into water supply, contaminating entire facility. Cross-connections spread pathogens throughout plumbing. Sewage backups create immediate health hazard. Can affect hundreds through contaminated water.
Install backflow preventers on ALL required fixtures. Maintain air gaps (2x pipe diameter minimum). Fix all leaks immediately. Ensure proper drainage - no standing water. Regular plumbing inspection. No direct connections between sewage and water supply.
10I
NYC Health Code Violation 10I
Single service item reused, improperly stored, dispensed; not used when required.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 10I to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Follow NYC Health Code Article 81 requirements. Implement corrective action immediately. Document all corrections. Train staff on proper procedures. Schedule follow-up inspection if critical.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
Violations were cited in the following area(s).