BLUE MAIZ
SCORE: 32 POINTSTuesday, November 23, 2021
Violations Cited
02B
Hot TCS Food Not Held at 140°F or Above
Hot food item not held at or above 140º F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
06A
Personal cleanliness inadequate
Personal cleanliness inadequate. Outer garment soiled with possible contaminant. Effective hair restraint not worn in an area where food is prepared.
Poor hygiene transfers pathogens; contaminated clothing spreads bacteria throughout facility
Clean outer garments; hair restraints; no jewelry; short, clean fingernails; no nail polish
09C
Food contact surface improperly constructed
Food contact surface not properly maintained.
Improper surfaces harbor bacteria in cracks and cannot be properly sanitized
Use stainless steel, approved plastics; no wood except cutting boards; smooth, intact surfaces
04N
Filth Flies Present in Food Areas
Filth flies or food/refuse/sewage-associated (FRSA) flies present in facility’s food and/or non-food areas. Filth flies include house flies, little house flies, blow flies, bottle flies and flesh flies. Food/refuse/sewage-associated flies include fruit flies, drain flies and Phorid flies.
RAPID CONTAMINATION: Flies carry 100+ pathogens on feet and bodies. One fly transfers 2 million bacteria per landing. Feed by vomiting on food. Can contaminate entire prep area in minutes. Major vector for E. coli, Salmonella, Shigella transmission.
Eliminate breeding sites: Clean drains daily, Remove standing water, Empty garbage frequently, Install air curtains/screens, Use fly lights away from food, Clean up spills immediately, Locate and eliminate larval breeding sites (drains, garbage, produce).
08A
Facility Not Free from Harborage Conditions
Facility not vermin proof. Harborage or conditions conducive to attracting vermin to the premises and/or allowing vermin to exist.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
Violations were cited in the following area(s).